LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 189 (Steering Wheel & Steering Column) >> Repair Instructions >> Transmission Control Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of AT Control & Bolts
    GM1858765Courtesy of GENERAL MOTORS CORP.
  1. Install the automatic transmission control (2).
    2. NOTE: Refer to Fastener Notice .
    IMPORTANT: Move the automatic transmission control as needed to install all the automatic transmission control bolts.
  2. Install the automatic transmission control bolts (1).

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    3. Fig 2: View Of AT Shift Lock Control Actuator
    GM1858766Courtesy of GENERAL MOTORS CORP.
  3. Connect the automatic transmission shift lock control actuator (1) to the automatic transmission control.
    4. Fig 3: Identifying Park Lock Cable At Ignition Lock Cylinder
    GM324874Courtesy of GENERAL MOTORS CORP.
  4. Connect the automatic transmission park lock cable (1).
    1. Place the ignition lock cylinder into the OFF position.
    2. Place the automatic transmission control into the PARK position.
    3. Press the locking tab on the end of the automatic transmission park lock cable into the slot in the ignition lock cylinder case.
  5. Install the shift lever. Refer to Shift Lever Replacement .
  6. Install the steering column. Refer to Steering Column Replacement (Two Mode Hybrid)  or Steering Column Replacement (Non-Hybrid) .
scientia non olet · About LEMON Manuals