LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 189 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Column Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Steering Column Seal & Nuts
    GM1861847Courtesy of GENERAL MOTORS CORP.
  1. Install the steering column seal (1) to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the 3 steering column seal nuts (2).

    Tighten:  Tighten the nuts to 3 N.m (27 lb in).

  3. Connect the steering shaft coupling to the upper intermediate steering shaft. Refer to Steering Shaft Coupling Replacement .
scientia non olet · About LEMON Manuals