LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 187 (Instrument Panel System Displays & Gages) >> Diagnostic Information and Procedures >> Clock Malfunction >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the clock.
  2. Ignition OFF, test for less than 5 ohms between the ground circuit terminal 2 and ground.
    • If greater than the specified value, test the ground circuit for a short to voltage or an open/high resistance.
  3. Verify that a test lamp illuminates between the B+ circuit terminal 1 and the ground circuit terminal 2.
    • If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
  4. If all circuits test normal, test or replace the clock.
scientia non olet · About LEMON Manuals