LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 186 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Defroster Door Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Exploded View Of HVAC Module Assembly
    GM962571Courtesy of GENERAL MOTORS CORP.
  1. Install the defroster door (8).
  2. Install the mode actuator cam assembly.
  3. Install the mode actuator.
    4. NOTE: Refer to FASTENER NOTICE .
  4. Install the mode actuator screws.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

  5. Install the HVAC module assembly halves.
    6. IMPORTANT: For every heat stake removed ensure that you install a screw.
  6. Install the screws to the HVAC module assembly.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

  7. Install the HVAC module. Refer to HVAC Module Assembly Replacement (Non-HP2)  or HVAC Module Assembly Replacement (HP2) .
scientia non olet · About LEMON Manuals