LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 186 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Compressor Mounting Bracket Replacement (Non HP2) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: A/C Compressor Bracket Mounting Bolts
    GM363185Courtesy of GENERAL MOTORS CORP.
  1. Install the A/C compressor bracket.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Install the A/C compressor bracket mounting bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  3. Install the A/C belt tensioner.
  4. Install the A/C belt tensioner bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  5. Install the A/C compressor. Refer to Air Conditioning Compressor Replacement (LY2, LY5, LH6, L76, L92 and LMG)  or Air Conditioning Compressor Replacement (HP2) .
scientia non olet · About LEMON Manuals