Compressor Mounting Bracket Replacement (HP2)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Compressor Mounting Bracket Replacement (HP2)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the air conditioning compressor. Refer to Air Conditioning Compressor Replacement (LY2, LY5, LH6, L76, L92 and LMG) or Air Conditioning Compressor Replacement (HP2) . Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the engine shield. Refer to Engine Shield Replacement . Remove the oil pan slid plate. Refer to Oil Pan Skid Plate Replacement (2500/3500 with RPO NZZ) or Oil Pan Skid Plate Replacement (1500 with RPO NZZ) . Remove transmission cooler bracket.
1	A/C Compressor Bracket Bolt NOTE: Refer to Fastener Notice . Tighten: 50 N.m (37 lb ft)
2	A/C Compressor Bracket Bolt (Qty: 2) Tighten: 50 N.m (37 lb ft)
3	A/C Compressor Bracket Bolt (Qty: 3) Tighten: 50 N.m (37 lb ft)
4	A/C Compressor Bracket