LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 186 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Auxiliary Heater Inlet and Outlet Hose Connector Retainer and Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the cooling system. Refer to Cooling System Draining and Filling (Static Fill) .
    2. Fig 1: Components Of Service Kit
    GM1887996Courtesy of GENERAL MOTORS CORP.
  2. Before removing the quick connect fitting from the vehicle, clean area and remove any loose dirt or debris.
  3. Remove the fitting from the tube by squeezing the retainer clip legs together and pulling the fitting from the tube.
  4. Remove the retainer from the tube by folding the legs back on themselves and sliding the retainer clip out of the tube (1).
  5. Place a flat-blade tool through the window of the quick connect fitting to just below the outer bushing and above the top O-ring (2).
    6. NOTE: Do NOT damage the fitting while removing the outer bushing. Damage may affect the seal integrity and cause a coolant leak.
  6. Remove the outer bushing with a gentle prying motion. Discard the outer bushing.
  7. Remove other components and discard.
  8. Thoroughly clean and inspect the inside surface of the fitting for nicks, scratches or cracks.

    Remove any dirt or debris using water and a lint free cloth.

scientia non olet · About LEMON Manuals