Auxiliary Blower Motor Replacement (Tahoe/Yukon/Denali/Escalade)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Auxiliary Blower Motor (Tahoe/Yukon/Denali/Escalade)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the right rear quarter trim panel. Refer to Rear Quarter Trim Panel Replacement - Right Side (Standard Wheelbase) or Rear Quarter Trim Panel Replacement - Right Side (Extended Wheelbase) . Disconnect the blower motor electrical connector.
1	Locking Tab (Qty: 2) Procedure Remove one attaching screw securing blower motor if applicable Carefully pull back locking tabs on blower motor assembly.
2	Auxiliary Blower Motor Assembly Procedure: Rotate blower motor counterclockwise to remove.

Callout

Component Name

Preliminary Procedure

Remove the right rear quarter trim panel. Refer to Rear Quarter Trim Panel Replacement - Right Side (Standard Wheelbase) or Rear Quarter Trim Panel Replacement - Right Side (Extended Wheelbase) .
Disconnect the blower motor electrical connector.

Locking Tab (Qty: 2)

Procedure

Remove one attaching screw securing blower motor if applicable
Carefully pull back locking tabs on blower motor assembly.

Auxiliary Blower Motor Assembly
Procedure:
Rotate blower motor counterclockwise to remove.