LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 186 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Air Inlet Assembly Replacement

Air Inlet Assembly Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Air Inlet Assembly & Components
GM1707457Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Remove the HVAC module assembly. Refer to HVAC Module Assembly Replacement (Non-HP2)  or HVAC Module Assembly Replacement (HP2) .
  2. Disconnect the electrical connector from the recirculation actuator.
1 Recirculation Actuator Screw (Qty: 2)
NOTE: Refer to Fastener Notice .

Tighten:  1.5 N.m (13 lb in)
2 Recirculation Actuator
3 Air Inlet Assembly Screw (Qty: 2)

Tighten:  1.5 N.m (13 lb in)
4 Air Inlet Assembly
Tip:  Tilt the rear of the air inlet assembly upward to release front mounting tabs.
scientia non olet · About LEMON Manuals