LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 186 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Air Conditioning Cycling Switch Replacement (Non-HP2) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new O-ring seal to the switch. Refer to O-Ring Replacement .
    2. Fig 1: A/C Low Pressure Switch
    GM660417Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the A/C low pressure switch to the accumulator.

    Tighten:  Tighten the switch to 6 N.m (53 lb in).

  3. Connect the electrical connector to the A/C low pressure switch.
  4. Leak test the fittings of the components using the J 39400-A  . See Special Tools .
scientia non olet · About LEMON Manuals