Removal Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Recover the refrigerant. Refer to Refrigerant Recovery and Recharging (Non HP2) or Refrigerant Recovery and Recharging (HP2) .
- Install a ratchet into the air conditioning (A/C) belt tensioner adapter opening.
- Remove the air cleaner resonator outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
- Rotate the A/C belt tensioner clockwise in order to relieve the tension on the belt.
- Remove the A/C belt from the A/C compressor.
- Slowly release the tension on the A/C belt tensioner.
- Remove the discharge hose bolt from the A/C compressor.
- Remove the discharge hose from the A/C compressor.
- Remove the suction hose bolt from the A/C compressor.
- Remove the suction hose from the A/C compressor.
- Discard the sealing washers. Cap all of the openings.
- Disconnect the electrical connections.
- Remove the A/C compressor mounting bolts. The lower right bolt (3) will stay with the compressor due to a lack of clearance.
- Remove the A/C compressor (2) from the bracket (1).
- If replacing the A/C compressor. Refer to Air Conditioning Compressor Oil Balancing (HP2) or Air Conditioning Compressor Oil Balancing (Non-HP2) .