LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 182 (Sunroof System) >> Repair Instructions >> Sunroof Window Height and Opening Fit Adjustment >> Window Height Set

Window Height Set

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Slide the sunroof sunshade to the open position.
  2. Remove the sunroof panel side covers. Refer to Sunroof Panel Side Opening Closeout Cover Replacement .
  3. Cycle the sunroof to the fully closed position.
  4. Loosen the sunroof window panel screws.
    5. Fig 1: Checking Corners Of Sunroof Window Panel
    GM1685761Courtesy of GENERAL MOTORS CORP.
  5. Individually adjust the 4 corners of the sunroof window panel.
  6. Adjust the front of the sunroof window panel to 0.0 - 1.0 mm (0.040 in) below the top surface (3) of the roof panel.
  7. Adjust the rear of the sunroof window panel to 1.0+0.0 mm (0.040 in) above the top surface (2) of the roof panel.
    8. NOTE: Refer to Fastener Notice .
  8. Tighten the sunroof window panel screws.

    Tighten:  Tighten the sunroof window panel screws to 4 N.m (35 lb in).

  9. Install the sunroof panel side covers. Refer to Sunroof Panel Side Opening Closeout Cover Replacement .
  10. Close the sunshade.
scientia non olet · About LEMON Manuals