Sunroof Panel/Window Garnish Molding Replacement (Crew Cab)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Sunroof Panel/Window Garnish Molding (Crew Cab)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Sunroof Panel/Window Garnish Molding Assembly Tip: Tilt molding approximately 45 degrees with rear end up. Push molding rearward to sandwich headliner and sunroof tub between molding flange and tabs. Grab front of molding at centerline and pull rearward approximately 1 inch. Push front edge up, locking front tabs in place. Push up on outboard edges of molding to secure. After molding is secured, slide the molding forward until it stops.

Callout

Component Name

Sunroof Panel/Window Garnish Molding Assembly
Tip:

Tilt molding approximately 45 degrees with rear end up.
Push molding rearward to sandwich headliner and sunroof tub between molding flange and tabs.
Grab front of molding at centerline and pull rearward approximately 1 inch.
Push front edge up, locking front tabs in place.
Push up on outboard edges of molding to secure.
After molding is secured, slide the molding forward until it stops.