LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 182 (Sunroof System) >> Diagnostic Information and Procedures >> Power Sunroof Inoperative >> Component Testing

Component Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Sunroof Switch

  1. Ignition OFF, disconnect the harness connector at the sunroof switch.
  2. Test for infinite resistance between the switch terminals listed below and the ground circuit terminal 5 with the switch in the neutral position.
    • Express open/close terminal 1
    • Sunroof close terminal 4
    • Sunroof open terminal 6
    • Vent close terminal 8
    • Vent open terminal 2
    • If not the specified value, replace the sunroof switch.
  3. Test for less than 5 ohms between the switch terminals listed below and the ground circuit terminal 5 with the switch in the appropriate position.
    • Express open/close terminal 1
    • Sunroof close terminal 4
    • Sunroof open terminal 6
    • Vent close terminal 8
    • Vent open terminal 2
    • If greater than the specified value, replace the sunroof switch.