LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 180 (Hybrid Energy Storage System) >> Diagnostic Information and Procedures >> DTC P0A9C-P0A9E, P0AC6-P0AC8, P0ACB-P0ACD, P0AE9, P0AEA, or P0AEB >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, observe all four hybrid battery module temperature sensor parameters with a scan tool. The hybrid battery temperature parameters should be between -39 and +95°C (-38 and +203°F) with no more than 15°C (27°F) difference between the four temperature sensors.
  2. Operate the vehicle within the Conditions for Running the DTCs. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records Data.
scientia non olet · About LEMON Manuals