LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 180 (Hybrid Energy Storage System) >> Diagnostic Information and Procedures >> DTC P0A80 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, observe the DTC information with a scan tool. DTC P0A80 should not set.
  2. Operate the vehicle within the Conditions for Running the DTCs. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  3. Verify the hybrid battery resistance values on the scan tool are less than the resistance values specified in the Drive Motor Generator Battery End of Life Resistance .
scientia non olet · About LEMON Manuals