LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Transfer Case - BW 4484) >> Repair Instructions >> Transfer Case Shift Control Module Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Transfer Case Shift Control Module
    GM860519Courtesy of GENERAL MOTORS CORP.
  1. Remove the knee bolster. Refer to Driver Knee Bolster Panel Replacement .
  2. Disconnect the shift control module electrical connectors.
  3. Reposition the harness.
  4. Remove the module from the vehicle.
scientia non olet · About LEMON Manuals