LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Transfer Case - BW 4484) >> Repair Instructions >> Transfer Case Shift Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Transfer Case Shift Control Module
    GM860519Courtesy of GENERAL MOTORS CORP.
  1. Install the shift control module to the vehicle.
  2. Connect the shift control module electrical connectors.
  3. Install the knee bolster. Refer to Driver Knee Bolster Panel Replacement .
  4. Start the engine and test the automatic transfer case system for proper shift operation.
scientia non olet · About LEMON Manuals