LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Transfer Case - BW 4484) >> Repair Instructions >> Transfer Case Output Shaft Seal Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Rear Output Shaft Seal Using J 45756
    GM833029Courtesy of GENERAL MOTORS CORP.
  1. Using J 45756  , install a NEW front output shaft seal. See Special Tools .
  2. Install the rear propeller shaft. Refer to Rear Propeller Shaft Replacement .
  3. Check the fluid level. Add fluid, if necessary.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals