LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Transfer Case - BW 4484) >> Repair Instructions >> Transfer Case Output Shaft Seal Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Using J 43484 & J 8092 On Front Output Shaft Seal
    GM819655Courtesy of GENERAL MOTORS CORP.
  1. Using the J 43484  (2) and the J 8092  (1), install the transfer case output seal.
  2. Install the front propeller shaft. Refer to Front Propeller Shaft Replacement .
  3. Check the transfer case fluid level. Refer to Transfer Case Fluid Replacement .
  4. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
scientia non olet · About LEMON Manuals