LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Transfer Case - BW 4484) >> Repair Instructions >> Transfer Case Input Shaft Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the transfer case from the adapter. Refer to Transfer Case Assembly Replacement .
    3. Fig 1: Removing Input Shaft Seal Using J 23907 & J 36825
    GM819621Courtesy of GENERAL MOTORS CORP.
  3. Using the J 36825  remove the input shaft seal from the transfer case by threading the self tapping screw (2) into the seal. See Special Tools .
scientia non olet · About LEMON Manuals