Installation Procedure
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Apply pipe sealant GM P/N 12346004 (Canadian P/N 10953480) to the threads on the drain plug.
- Install the drain plug in the transfer case.
Tighten: Tighten the drain plug to 25 N.m (18 lb ft).
- Fill the transfer case to the bottom of the fill hole with the proper fluid.
- Apply pipe sealant GM P/N 12346004 (Canadian P/N 10953480) to the threads on the drain plug.
- Install the fill plug.
Tighten: Tighten the fill plug to 25 N.m (18 lb ft).
- Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
NOTE:
Refer to Fastener Notice
.
IMPORTANT:
If the drain or fill plug have to be replaced, used only aluminum replacement drain plugs.