LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Transfer Case - BW 4484) >> Repair Instructions >> Transfer Case Adapter Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Support the transmission with a suitable jack stand.
    3. Fig 1: Transmission Support
    GM794684Courtesy of GENERAL MOTORS CORP.
  3. Remove the rear crossmember from the frame.
  4. Remove the transfer case from the vehicle. Refer to Transfer Case Assembly Replacement .
    5. Fig 2: Adapter To Transmission Mounting Bolts
    GM860431Courtesy of GENERAL MOTORS CORP.
  5. Remove the mounting bolts from the adapter to the transmission.
  6. Remove the adapter from the transmission (automatic shown).
  7. Remove the seal between the transfer case and the adapter.
  8. Remove the gasket from the adapter.
scientia non olet · About LEMON Manuals