LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 179 (Seat Belt System) >> Diagnostic Information and Procedures >> Seat Belt Indicator Circuit Malfunction - Passenger >> Diagnostic Fault Information

Diagnostic Fault Information

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Circuit Short to Ground Open/High Resistance Short to Voltage Signal Performance
Low Reference - 2 - -
Seat Belt Switch Signal 1 2 - -
Ignition 1 Voltage 3 3 - -
Passenger Seat Belt Indicator Control 4 5 - -
  1. The passenger seat belt indicator will remain ON with seat occupied and the seat belt buckled.
  2. The passenger seat belt indicator will not illuminate with the seat occupied and the seat belt disconnected, but will illuminate for the bulb test.
  3. No indicator on the inflatable restraint passenger air bag ON/OFF indicator will illuminate at any time.
  4. The passenger seat belt indicator will illuminate at all times.
  5. The passenger seat belt indicator will never illuminate but the PPS ON/OFF indicator does.
scientia non olet · About LEMON Manuals