LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 178 (Instrument Panel Trim And Console Trim) >> Repair Instructions >> Instrument Panel Compartment Door Lock Cylinder Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Depressing Retainer Tumbler Through Poke Hole
    GM641756Courtesy of GENERAL MOTORS CORP.
  1. Remove the instrument panel compartment latch. Refer to Instrument Panel Compartment Door Latch Replacement (Cadillac)  or Instrument Panel Compartment Door Latch Replacement (Except Cadillac) .
  2. Position the instrument panel compartment latch fork bolt in the up position.
  3. Insert the key into the instrument panel compartment lock cylinder.
  4. Rotate the instrument panel compartment lock cylinder clockwise to the 3 o'clock position with the key.
  5. With the key in position, apply a light load and depress the retainer tumbler through the poke hole at the right hand side of the instrument panel compartment latch.
    6. Fig 2: Rotating Key To 5 O'Clock
    GM641556Courtesy of GENERAL MOTORS CORP.
  6. Rotate the key until the instrument panel compartment lock cylinder rotates to about the 5 o'clock position.

    This will line up the notch at the rear of the instrument panel compartment lock cylinder with the tab in the instrument panel compartment latch housing.

    7. Fig 3: Identifying I/P Compartment Door Lock Cylinder
    GM641536Courtesy of GENERAL MOTORS CORP.
  7. Remove the instrument panel compartment lock cylinder from the instrument panel compartment latch by pulling on the key.
scientia non olet · About LEMON Manuals