LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 178 (Instrument Panel Trim And Console Trim) >> Repair Instructions >> Instrument Panel Compartment Door Lock Cylinder Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying I/P Compartment Door Lock Cylinder
    GM641536Courtesy of GENERAL MOTORS CORP.
  1. Position the instrument panel compartment latch fork bolt in the up position.
  2. Grasp the instrument panel compartment lock cylinder. Depress the rear-most, light-colored tumbler that is flush with the instrument panel compartment lock cylinder surface.
  3. Insert the key.

    All the tumblers will now stay depressed.

  4. Insert the instrument panel compartment lock cylinder, with the key inserted, into the instrument panel compartment latch housing. Ensure that the front projection pin is at the appropriate 8 o'clock position.

    The instrument panel compartment lock cylinder will drop into place.

  5. Rotate the key counterclockwise until the key stops.
  6. Remove the key, the tumblers will now release.

    The instrument panel compartment lock cylinder is now locked into the instrument panel compartment latch housing.

  7. Install the instrument panel compartment latch. Refer to Instrument Panel Compartment Door Latch Replacement (Cadillac)  or Instrument Panel Compartment Door Latch Replacement (Except Cadillac) .
scientia non olet · About LEMON Manuals