Rear Seat Number 2 Back Cushion Hinge Finish Cover Replacement (AW2)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Seat No.2 Back Cushion Hinge Finish Cover & Screw

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Rear Seat No. 2 Back Cushion Hinge Finish Cover Screw NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
2	Rear Seat No. 2 Back Cushion Hinge Finish Cover Tip: Tilt the opposite seat forward to allow access to the inner finish cover. Pull away from the seat to disengage the integral retainers.