LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 177 (Seat Hardware, Seat Trim And Upholstery) >> Repair Instructions >> Rear Seat Cushion Outer Trim Panel Replacement (with ARS)

Rear Seat Cushion Outer Trim Panel Replacement (with ARS)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Rear Seat Cushion Outer Trim Panel & Components
GM1684824Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Rear Seat Recliner Outer Finish Cover Nut
NOTE: Refer to Fastener Notice .

Tip:  The nut is located in a recessed hole on the inboard side of the outer trim panel.

Tighten:  2 N.m (18 lb in)

2 Rear Seat Recliner Handle
Refer to Rear Seat Recliner Handle Replacement (Tahoe/Yukon/Escalade with Bucket) .
3 Rear Seat Recliner Outer Finish Cover
Tip:  Pull outward to disengage the retainer clips.