LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 177 (Seat Hardware, Seat Trim And Upholstery) >> Repair Instructions >> Lumbar Support Actuator Replacement (with HP2)

Lumbar Support Actuator Replacement (with HP2)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Lumbar Support Actuator Replacement (With HP2)
GM1966908Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Remove the front seat back cushion cover and pad. Refer to Front Seat Back Cushion Cover and Cushion Pad Replacement (with HP2)  or Front Seat Back Cushion Cover and Cushion Pad Replacement (without HP2) .
  2. Remove the front seat cushion cover and pad. Refer to Seat Cushion Trim Cover and Pad Replacement (with HP2)  or Seat Cushion Trim Cover and Pad Replacement (without HP2) .
1 Front Seat Lumbar Support Actuator Assembly Screw
NOTE: Refer to Fastener Notice .

Tip:  Twist actuator to unlock it from seat front once screw is removed.

Tighten:  3 N.m (27 lb in)
2 Front Seat Lumbar Support Actuator Assembly

Procedure

  1. Remove the actuator assembly from the seat cushion frame.
  2. Note the routing of the actuator assembly for installation.
  3. Remove the actuator assembly from the seat back cushion frame and lumbar support.
scientia non olet · About LEMON Manuals