LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 177 (Seat Hardware, Seat Trim And Upholstery) >> Repair Instructions >> Front Seat Head Restraint Replacement (With AYE)

Front Seat Head Restraint Replacement (With AYE)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Front Seat Head Restraint (With AYE)
GM2037467Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedures: 
Remove Front Seat Back Cushion Finish Panel. Refer to Driver or Passenger Seat Back Cushion Finish Panel Replacement (with HP2)  or Driver or Passenger Seat Back Cushion Finish Panel Replacement (without HP2) 
1 Front Seat Head Restraint

Procedure

  1. Depress the button on the inboard head restraint guide to raise the head restraint to the full up position.
  2. Insert small tool into opposite head restraint retainer to release.
  3. Tie a wire or string to the end of the DVD cable in order to aid in the installation of the new Front Seat Head Restraint.
  4. Disconnect the electrical connector.
scientia non olet · About LEMON Manuals