LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 175 (Interior Trim And Paneling) >> Repair Instructions >> Front Side Door Opening Frame Garnish Molding Replacement

Front Side Door Opening Frame Garnish Molding Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Front Side Door Window Garnish Molding & Retainers
GM1674933Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedures: 
Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
1 Front Side Door Window Garnish Molding Retainer (Qty: 6)
2 Front Side Door Window Garnish Molding
Tip: 
  1. Install the 3 clips in the corners over the flange.
  2. Install the tab at each end of the garnish molding between the flange and reveal molding.
  3. Install the remaining 3 clips around the window flange.