Rear Bumper Fascia Trailer Hitch Access Hole Cover Replacement (Escalade, Denali)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Bumper Fascia Trailer Hitch Access Hole Cover & Locking Screws

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Push Pins (Qty: 2)
2	Rear Bumper Fascia Trailer Hitch Accessory Hole Cover Procedure To remove, turn the fasteners on the lower tabs 90 degrees counterclockwise. Grip the lower edge of the cover and rotate up and out approximately 45 degrees. Disengage the upper attachments on cover by pulling down. To install, hold cover at a 45 degree angle to vehicle and engage upper tabs on the hitch cover into the chrome slots in fascia. Rotate the bottom of cover forward until the lower tabs align with the lower fascia slots. Snap hitch cover into place by pushing the upper corners forward. Turn the fasteners 90 degrees clockwise to lock.

Callout

Component Name

Push Pins (Qty: 2)

Rear Bumper Fascia Trailer Hitch Accessory Hole Cover

Procedure

To remove, turn the fasteners on the lower tabs 90 degrees counterclockwise.
Grip the lower edge of the cover and rotate up and out approximately 45 degrees.
Disengage the upper attachments on cover by pulling down.
To install, hold cover at a 45 degree angle to vehicle and engage upper tabs on the hitch cover into the chrome slots in fascia.
Rotate the bottom of cover forward until the lower tabs align with the lower fascia slots.
Snap hitch cover into place by pushing the upper corners forward.
Turn the fasteners 90 degrees clockwise to lock.