Rear Side Door Hinge Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
|
CAUTION:
Refer to SIR Caution
.
IMPORTANT:
Replace only one hinge at a time. Preliminary Procedure: Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling
. |
|
| 1 | Rear Side Door Hinge Upper Bolts (Qty: 2)
NOTE:
Fastener Notice
.
Tighten: 25 N.m (18 lb ft) |
| 2 | Rear Side Door Hinge Upper Bolts (Qty: 2) Tighten: 25 N.m (18 lb ft) |
| 3 | Rear Side Door Upper Hinge Tip: Check the door for proper alignment, then adjust as necessary. |
| 4 | Rear Side Door Hinge Lower Bolt Tighten: 25 N.m (18 lb ft) Tip: After installation of the replacement upper hinge, from the underside of the hinge, remove the temporary keeper pivot bolt and replace with longer permanent bolt. |
| 5 | Rear Side Door Hinge Lower Bolts (Qty: 2) Tighten: 25 N.m (18 lb ft) |
| 6 | Rear Side Door Hinge Lower Bolts (Qty: 2) Tighten: 25 N.m (18 lb ft) |
| 7 | Rear Side Door Lower Hinge Tip: Check the door for proper alignment, then adjust as necessary. |