LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 173 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Rear Door Opening Weatherstrip Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Pinch-Weld Flange Weatherstrip (Rear Door Opening)
    GM686586Courtesy of GENERAL MOTORS CORP.
  1. Align the weatherstrip to the door opening with the 2 dots positioned on the upper right and left side.
  2. Align the weatherstrip to the door opening with the bond joint positioned at the lower center of the door opening.
  3. Install the weatherstrip to the pinch-weld flange. Ensure that the weatherstrip is fully seated.
scientia non olet · About LEMON Manuals