LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 173 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Rear Compartment Access Door Weatherstrip Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Midgate Lower Weatherstrip
    GM787958Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: To begin the installation of the weatherstrip, ensure the weatherstrip is at a minimum of 21°C (70°F).
  1. Starting from one end of the weatherstrip, install the weatherstrip.
  2. Ensure the corners of the weatherstrip are fully seated.
  3. Install the midgate. Refer to Midgate Replacement .
  4. Close the midgate.
  5. Install the rear removable rear glass panel.
  6. Inspect the weatherstrip when the midgate is closed and the glass panel installed.
  7. Set the rear seat in the upright position.
scientia non olet · About LEMON Manuals