LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 173 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Door Check Link Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the check strap to the door.
  2. Install the check strap to the body.
    3. Fig 1: View Of Door Check Link & Bolt
    GM348484Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the check strap nuts.

    Tighten:  Tighten the nuts to 9 N.m (80 lb in).

  4. Install the check strap bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb in).

  5. Install the water deflector. Refer to Front Side Door Water Deflector Replacement .
  6. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .
scientia non olet · About LEMON Manuals