Front Fog Lamp Replacement (PLATINUM)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front Fog Lamp Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the front lower bumper filler. Refer to Front Bumper Filler Replacement (Z71) or Front Bumper Filler Replacement (All Utility, Avalanche, Cadillac EXT) . Disconnect the electrical connectors for the front park turn signal lamp and the front fog lamp sockets. The bulbs can be removed after the lamp housing has been removed from the front bumper fascia.
1	Nuts (Qty: 3) NOTE: Refer to Fastener Notice . Tighten: 10 N.m (89 lb in)
2	Front Fog Lamp Assembly Tip: Remove the lamp assembly from the front side of the lower bumper fascia.
3	Fog Lamp Bulb CAUTION: Refer to Halogen Bulb Caution . Tip: Rotate the bulb socket counterclockwise in order to remove.
4	Park, Turn Signal Lamp Bulb Socket Tip: Rotate the bulb socket counterclockwise in order to remove.
5	Park, Turn Signal Lamp Bulb Tip: Pull the bulb straight from the socket.