Rear Window Wiper Arm Parking Ramp Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Window Wiper Arm Parking Ramp

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Open the liftgate. Remove the interior liftgate trim panel. Refer to Liftgate Trim Panel Replacement .
1	Rear Window Wiper Arm Park Ramp Nut NOTE: Refer to Fastener Notice . Tighten: 9 N.m (80 lb in)
2	Rear Window Wiper Arm Park Ramp Tip: Upon installation, align the pin in the rear of the ramp to the hole in the liftgate outer panel.

Callout

Component Name

Preliminary Procedure

Open the liftgate.
Remove the interior liftgate trim panel. Refer to Liftgate Trim Panel Replacement .

Rear Window Wiper Arm Park Ramp Nut

NOTE: Refer to Fastener Notice .

Tighten: 9 N.m (80 lb in)

Rear Window Wiper Arm Park Ramp
Tip: Upon installation, align the pin in the rear of the ramp to the hole in the liftgate outer panel.