Circuit/System Description
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
The rear window washer pump is controlled by the rear window wiper washer switch through the rear washer pump relay. The ignition voltage is from the body control module (BCM), and when the WASH switch is pressed B+ is applied to the rear washer relay control circuit and to the rear wiper switch signal circuit. When the rear wiper motor module receives B+ on the rear wiper switch signal circuit, the wiper motor will operate continuously for as long as the voltage is present and several cycles after the switch is released. The rear washer relay control circuit is used to energize the relay coil and close the rear washer pump control circuit to B+.