LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (HVAC - Automatic) >> Repair Instructions >> Sun Load Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Sun Load Sensor & I/P Upper Trim Pad
    GM870457Courtesy of GENERAL MOTORS CORP.
  1. Remove the I/P upper trim pad. Refer to Instrument Panel Upper Trim Pad Replacement .
  2. Remove the sun load sensor from the I/P upper trim pad by turning counter clockwise.
  3. Disconnect the electrical connector from the sun load sensor.
scientia non olet · About LEMON Manuals