LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (HVAC - Automatic) >> Repair Instructions >> Mode Actuator Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Floor Air Outlet Duct
    GM810840Courtesy of GENERAL MOTORS CORP.
  1. Remove the push pin (5) from the HVAC module assembly (1).
  2. Remove the left floor duct (3) from the HVAC module assembly (1).
    3. Fig 2: View Of Mode Actuator
    GM826791Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the electrical connector (3) from the mode actuator (4).
  4. Remove the screws from the mode actuator (4).
  5. Remove the mode actuator (4) from the HVAC module assembly (1).
  6. Remove the cam (2) from the HVAC module assembly (1).
scientia non olet · About LEMON Manuals