LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (HVAC - Automatic) >> Repair Instructions >> Blower Motor Control Processor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Blower Motor Control Processor & HVAC Module Assembly
    GM826796Courtesy of GENERAL MOTORS CORP.
  1. Remove the I/P insulator panel. Refer to Instrument Panel Insulator Replacement .
  2. Disconnect the electrical connector (2) from the blower motor (1).
  3. Disconnect the electrical connector (4) from the blower motor control processor (3).
  4. Remove the screws from the blower motor control processor (3).
  5. Remove the blower motor control processor (3) from the HVAC module assembly.
scientia non olet · About LEMON Manuals