Conditions for Clearing the DTC

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

The DTC will become history if the HVAC control module no longer detects the condition that set the DTC.
The history DTC will clear after 100 fault-free ignition cycles.
The DTC can be cleared with a scan tool.

DTC B1375

Step	Action	Yes	No
Schematic Reference: HVAC Schematics Connector End View Reference: HVAC Connector End Views
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Install a scan tool. Turn ON the ignition, with the engine OFF. Select the HVAC control module display DTC function on the scan tool. Does the scan tool indicate that B1375 is a current DTC?	Go to Step 3	Go to Testing for Intermittent Conditions and Poor Connections
3	Turn OFF the ignition. Disconnect the HVAC control module. Turn ON the ignition, with the engine OFF. Probe the ignition 3 voltage circuit with a test lamp that is connected to a good ground. Does the test lamp illuminate?	Go to Step 4	Go to Step 5
4	Inspect for poor connections at the harness connector of the HVAC control module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition?	Go to Step 7	Go to Step 6
5	Repair the ignition 3 voltage circuit. Refer to Wiring Repairs . Did you complete the repair?	Go to Step 7	-
6	Replace the HVAC control module. Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement?	Go to Step 7	-
7	Use the scan tool in order to clear the DTCs. Operate the vehicle within the Conditions for Running the DTC, as specified in the supporting text. Does the DTC reset?	Go to Step 3	System OK