Liftgate Emblem/Nameplate Replacement (PLATINUM)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Liftgate Emblem/Nameplate

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Liftgate Nameplate Assembly (Platinum) NOTE: Refer to Exterior Trim Emblem Removal Notice . Procedure The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength. Use a J 25070 Heat Gun or equivalent to remove the old nameplate/emblem. Clean all adhesive from rear liftgate and wipe the surface dry with a clean lint-free towel prior to installing the new emblem. When removing protective liners from the adhesive tape, be careful not to touch tape with hands and do not allow tape to come in contact with dirt or any foreign matter prior to adhesion. Close the liftgate lid. Wet out the nameplate/emblem and ensure full adhesion of the nameplate is made to the liftgate.

Callout

Component Name

Liftgate Nameplate Assembly (Platinum)

NOTE: Refer to Exterior Trim Emblem Removal Notice .

Procedure

The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength.
Use a J 25070 Heat Gun or equivalent to remove the old nameplate/emblem. Clean all adhesive from rear liftgate and wipe the surface dry with a clean lint-free towel prior to installing the new emblem.
When removing protective liners from the adhesive tape, be careful not to touch tape with hands and do not allow tape to come in contact with dirt or any foreign matter prior to adhesion.
Close the liftgate lid.
Wet out the nameplate/emblem and ensure full adhesion of the nameplate is made to the liftgate.