Front Fender Lower Rear Molding Replacement (Chevrolet Tahoe Two-mode Hybrid)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front Fender Lower Rear Molding

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Front Fender Lower Rear Molding Assembly Screw (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
2	Front Fender Lower Rear Molding Assembly Procedure When removing protective liners from adhesive tape, be careful not to touch tape with hands and do not allow tape to come in contact with dirt or any foreign matter prior to adhesion. Use a J 25070 or equivalent to remove the front fender lower rear molding. Clean all adhesive from the front fender using a 50/50 mixture of isopropyl alcohol and clean water. Wipe the surface dry with a clean lint-free towel prior to installing new front fender lower molding. Align the molding the front fender, secure the two wheelhouse liner screws. Peel adhesive tape protective liner from molding and secure the front fender lower rear molding.
3	Adhesive Tape Tip: Peel the adhesive tape liner and wet out the rearward edge of the molding to the front fender lower panel.

Callout

Component Name

Front Fender Lower Rear Molding Assembly Screw (Qty: 2)

NOTE: Refer to Fastener Notice .

Tighten: 2 N.m (18 lb in)

Front Fender Lower Rear Molding Assembly

Procedure

When removing protective liners from adhesive tape, be careful not to touch tape with hands and do not allow tape to come in contact with dirt or any foreign matter prior to adhesion.
Use a J 25070 or equivalent to remove the front fender lower rear molding.
Clean all adhesive from the front fender using a 50/50 mixture of isopropyl alcohol and clean water.
Wipe the surface dry with a clean lint-free towel prior to installing new front fender lower molding.
Align the molding the front fender, secure the two wheelhouse liner screws.
Peel adhesive tape protective liner from molding and secure the front fender lower rear molding.

Adhesive Tape
Tip: Peel the adhesive tape liner and wet out the rearward edge of the molding to the front fender lower panel.