Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Clean the area where the replacement molding is to be mounted. Use a suitable solvent such as flash naphtha or a mixture of 50 percent isopropyl alcohol and 50 percent water.
- Dry the area thoroughly.
- Warm the body panel to a temperature range of 16-41°C (60-105°F) with a heat lamp or with a heat gun.
- Ensure the molding is at a minimum temperature of 16°C (60°F).
If the temperature of the molding is below 16°C (60°F), warm the molding with a heat lamp or with a heat gun.
- Remove the protective tape.
- Without allowing the adhesive surface to touch the body, ensure the molding is aligned.
- Press on the molding in order to install the molding to the door.
IMPORTANT:
Apply the molding in an environment free of dust and of dirt. Dust and dirt may come in contact with the adhesive surface and prevent proper binding.
IMPORTANT:
Do not touch the adhesive surface when the tape is removed.