Decal or Stripe Replacement (Tahoe Two-Mode Hybrid Windshield)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Decal Or Stripe Location

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Heat the decal using a J 25070 or equivalent, 152 mm (6 in) from the glass surface. Apply the heat using a circular motion, for about 30 seconds. NOTE: Refer to Exterior Trim Emblem Removal Notice . Remove the decal from the surface using a plastic, flat-bladed tool. Remove all adhesive from the surface using a 3M™ Scotch Brite molding adhesive remover disk, 3M™ P/N 07501, or equivalent. Clean the surface using 3M™ General Purpose Adhesive Cleaner, P/N 08984 or equivalent. Special Tools: J 25070 Heat Gun 500-750°F
1	HYBRID Windshield Glass Decal Tip: The windshield glass decal is serviced as one part.

Callout

Component Name

Preliminary Procedures

Heat the decal using a J 25070 or equivalent, 152 mm (6 in) from the glass surface.
Apply the heat using a circular motion, for about 30 seconds.

NOTE: Refer to Exterior Trim Emblem Removal Notice .

Remove the decal from the surface using a plastic, flat-bladed tool.
Remove all adhesive from the surface using a 3M™ Scotch Brite molding adhesive remover disk, 3M™ P/N 07501, or equivalent.
Clean the surface using 3M™ General Purpose Adhesive Cleaner, P/N 08984 or equivalent.

Special Tools: J 25070 Heat Gun 500-750°F

HYBRID Windshield Glass Decal
Tip: The windshield glass decal is serviced as one part.