Decal or Stripe Replacement (Tahoe Two-Mode Hybrid Lower Door)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Decal Or Stripe Location

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Using a J 25070 or equivalent, in a circular motion, remove the old decal from both lower door panels. Remove all adhesives as follows: For metal body panels use a 3M Scotch Brite® molding adhesive remover disc, 3M P/N 07502 or equivalent. For plastic panels use a lint-free cloth with Varnish Makers and Painters (VMP) Naptha or a 50/50 mixture, by volume of isopropyl alcohol and clean drinkable water to remove left over adhesive. For the final preparation prior to application of the new decal, refer to Graphics/Decals/Emblems . Special Tools: J 25070 Heat Gun 500-750°F
1	HYBRID Lower Door Decal Tip: The lower door decal is serviced as one part.

Callout

Component Name

Preliminary Procedures

Using a J 25070 or equivalent, in a circular motion, remove the old decal from both lower door panels.
Remove all adhesives as follows:
- For metal body panels use a 3M Scotch Brite® molding adhesive remover disc, 3M P/N 07502 or equivalent.
- For plastic panels use a lint-free cloth with Varnish Makers and Painters (VMP) Naptha or a 50/50 mixture, by volume of isopropyl alcohol and clean drinkable water to remove left over adhesive.
For the final preparation prior to application of the new decal, refer to Graphics/Decals/Emblems .

Special Tools: J 25070 Heat Gun 500-750°F

HYBRID Lower Door Decal
Tip: The lower door decal is serviced as one part.