LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 168 (Exterior Trim) >> Repair Instructions >> Back Body Opening Upper Applique Replacement (Escalade)

Back Body Opening Upper Applique Replacement (Escalade)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Back Body Opening Rear Applique & Components
GM1672144Courtesy of GENERAL MOTORS CORP.
Callout Component Name
CAUTION: When a lift gate hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.
1 Rear Applique Screws (Qty: 3)
NOTE: Refer to Fastener Notice .

Tighten:  2 N.m (18 lb in)


Tip: 
  • Position the center screw to the applique first, followed by the hinge nuts second.
  • Install the outer screws last and torque the screws in the same sequence as shown.
2 Rear Applique Nuts (Qty: 2)

Tighten:  9 N.m (80 lb in)


Tip:  Disconnect the electrical connector.
3 Rear Applique
scientia non olet · About LEMON Manuals