LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 161 (Engine Mechanical - 4.8L, 5.3L, 6.0L And 6.2L (4 Of 5)) >> Off-Vehicle Repair Instructions (2 Of 3) >> Timing Chain and Sprockets Cleaning and Inspection

Timing Chain and Sprockets Cleaning and Inspection

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Timing Chain and Sprockets Inspection Areas
    GM1704628Courtesy of GENERAL MOTORS CORP.
  1. Clean the components with cleaning solvent.
    2. CAUTION: Refer to Safety Glasses and Compressed Air Caution .
  2. Dry the components with compressed air.
  3. Inspect the timing chain (1) for binding or wear.
  4. Inspect the camshaft position (CMP) sensor raised areas (2) for nicks or damage.
  5. Inspect for worn, damaged, or chipped teeth (3).
  6. Inspect for a damaged keyway (4).
  7. Inspect for worn oil pump drive splines (5).
    8. Fig 2: Timing Chain Tensioner Inspection Points
    GM1658210Courtesy of GENERAL MOTORS CORP.
  8. Inspect the timing chain tensioner for the following conditions:
    • Damaged or broken tension spring (1)
    • Excessive wear or scoring on the chain guide surfaces (2, 3)
scientia non olet · About LEMON Manuals